Vantaedge Integral Hover Spring Kit

The floating spring enables the KMFS Vantaedge Integral knife sharpener to be stabilized, especially with large sharpening angles. The floating spring is designed to be placed on the angle head or the additional multiangle head. The body of the floating spring is shaped in such a way that it is self-locking. In the set position, it lifts the angle head, the guide rods, the holder and the grinding stone. It is not necessary for the stone to be completely above the blade. This spring is not intended for sharpening on small blades if there is not enough space to place it. The stroke limiters are mounted on the guide rod, where they limit the upper position to prevent the stone from sliding over the edge of the blade when sharpening a wide blade and the lower position to prevent the whetstone and holder from sliding off the guide rods.

Warning and safety information:
Cut injuries: The most common danger when using knives is the risk of cuts. Sharp blades can quickly penetrate skin and tissue.
Slipping of the knife: Improper or excessive pressure can cause the knife to slip, resulting in uncontrolled movements that can cause injuries.
Injuries due to falls: Knives should never be left unsecured or near table edges to prevent them from falling and injuring someone.
Blunt knives: Blunt knives pose a greater risk of injury as they require more force and can slip more easily. Knives should therefore be properly sharpened regularly.
Improper use: Using a knife for tasks for which it is not intended (e.g. as a lever tool) can not only damage the blade, but also lead to accidents.